I couldn’t resist this print fabric and a roman blind is the perfect canvas for showing off the mid century design. Below I show you how to design and make your own really simple roman blind, lets do it right now!
You will need:
Pre-corded Roman Blind kit, I used one from John Lewis
Pins, needles, thread
Fabric, I used Villa Nova fabric
Measure the width and drop of your window for finished blind size. Add 1.5cm to the both sides and 6cm to the length, then cut out the fabric.
Wrong side up turn in the sides, fold the fabric over by 0.5cm and then a further 1cm, pin in place and sew down.
Take the loop tape off the head rail, turn the top of the blind over by 1cm, then pin the loop tape in place 0.5cm below the turn. Sew the loop tape in place along both edges.
To make the pocket for the bar on the lower edge fold the fabric up by 0.5cm then again by 4cm, sew in place.
To find the positions for the rod channels measure the length of the blind then divide into 6. Mark positions for the rod tape on the reverse of the blind, draw a light line from one side to the other.
To calculate the length of the channel tapes add 2cm to the width of the blind measurement then cut the channel tapes. Turn the side of the channel tape in by 1cm then using the lines you drew on the blind sew in position leaving one end of the channel open.
Cut the rods 2cm shorter than the width of the blind, insert into the channel through the opening. Turn in the tape by 1cm then close the opening by sewing onto the side of the blind, repeat for each rod.
Once you’ve made your Roman blind install it following your kit instructions, I used a pre-corded kit from John Lewis.
If you like this post check out my post on Quick Revamp for Drop-in Seat Chair